You are using Internet Explorer as your browser, which is no longer supported by our website. Because of this, you can view products but not place orders using Internet Explorer on our site.

Please update your browser to any of the modern browsers listed below or use a different internet browser to place an order on this site.

The Oatey Quiet Pipes Hammer Arrestors can be installed within minutes and doesn’t always require cutting your drywall. All you have to do is determine the connection type needed for your system and follow the steps below!

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

Hand screw the water arrestor to the water stop valve; use a tee fitting to aid the connection when necessary. The Hammer Arrestor can be installed in any directional position (horizontal, vertical, etc.) as needed.

Note: This guide concerns the application of typical bathroom piping set-ups from under the sink to the wall. For arrestors that install to the pipe, follow the installation per that type of pipe.

Turn off the water supply valve and disconnect the supply line. Use a small bucket or a shallow dish to catch any water remaining in the supply line. Be sure to dry the working area before continuing to the next step.

If you have any questions or need assistance with placing an order, please contact us at 800-825-2148 or [email protected]

If you are currently using Internet Explorer we recommend you switch to Edge or another supported browser to enjoy the best experience Oatey.com has to offer.

When flowing water in a plumbing system is suddenly halted or changes direction, it may result in a loud banging or hammering noise commonly known as water hammer. This can damage your system's fixtures and be quite annoying or disruptive to your home. The quick and easy installation of Oatey’s Quiet Pipes Hammer Arrestors is the perfect way to fix water hammer, killing the noise and preserving the integrity of your water pipes.