Boiler pressure relief valvedripping

Heatable Ltd is registered in England and Wales No. 08804726. Registered office is Glebe Business Park, Lunts Heath Road, Widnes, Cheshire, WA8 5SQ.

Pressure relief valve boilercost

Australian standards call for a maximum water pressure of 500 kPa for plumbing installations. Having water pressure above 500 kPa may damage connected products including water filters and will void the product warranty. If water pressure exceeds 500 kPa a watermark approved pressure limiting valve must be installed at the same time as installing the water filter system.

³Saving based on the average energy bill of a detached home when upgrading from a G-rated boiler to an A-rated boiler. Source: Energy Saving Trust

Boiler pressure relief valvedischarge pipe

Copyright Water Filters Australia 2024. All Rights Reserved. HIFLOW® is a trademark of Water Filters Australia Pty Limited. Website by Brilliant Digital.

The braided pex hoses and hex adapter (if supplied) are fitted with a sealing o-ring – teflon tape / joining compound is not required for this fitting. Check the fitting to ensure the o-ring is in place and not damaged. Ensure the inlet thread and mounting surface are smooth and clean. O-ring grease may be applied to the o-ring as required. Tighten until the o-ring contacts the surface of the filter head assembly inlet and outlet, then further tightened by 0.5 turns to reach approx 3.5 nm of force to compress the o-ring and effect a seal

Heatable Ltd is authorised and regulated by the Financial Conduct Authority, FRN 805259 We are a credit broker and not a lender and offer credit from a panel of lenders. We may receive commission if your application is successful and the amount may vary depending on the product chosen and the amount of credit taken out. Credit is provided subject to affordability, age and status. Minimum spend applies. Not all products offered are regulated by the Financial Conduct Authority